Panel Door with a four 2 over 2 panel layout it is beaded on both sides of the door
Made from: Pine
Internal use
Finish: Painted White one side & varnished the other.
*We offer a paint/varnish stripping service please get in touch to get a quote if you require this. We can also apply a new finished eg wax*
Used condition
Flaking paint ,Has a bit of old woodworm damage that has been treated ,Has not be cut square at the bottom,We have measured to make the door square,Some old lock holes ,Some old nail or screw holes ,Some scratches and marks
comes with steel hinges
As well as the description, we have taken 12 pictures, please look through them in detail.
4th picture shows lock holes
5th picture shows flaking paint
10th picture shows old lock holes
11th picture shows old pin holes around the edge on this side


Measurements:
Height: 192.8cm or 75 7/8"
**Height could be cut down by 7cm**
**2cm off the top 5cm off the bottom**
**Which could make the height as low as 185.8cm or 73 1/8 inches**

Width: 73.8cm or 29"
**Width could be cut by 3cm**
**Which could make it as narrow as 70.8cm or 27 3/4 inches**

Door Thickness: 3.5cm or 1 3/8 inches

**This information is a guide only, the amount that can be cut is from the top or the bottom or both and the same with the sides, it may be possible to cut more but it might effect the strength or look
Also note we measure using CM and then it gets converted to inches & rounded down to the nearest eighth (1/8) of an inch

Approximate Weight: 14kg or 30lbs
Approximate age: 1930s